Chertyozh Grindera G9

by

Catz 5 toyz downloads pc. • To obtain the Illustrated Parts Catalog, visit the Bunn-O-Matic website, at www.bunn.com. This is absolutely FREE, and the quickest way to obtain the catalog. Contact Bunn-O-Matic Corporation at 1-800-286-6070 to obtain a paper copy of the required Illustrated Parts Catalog mailed via U.S.

Postal Service. • AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND. In no event shall BUNN be liable for any other damage or loss, including, but not limited to, lost profits, lost sales, loss of use of equipment, claims of Buyer’s customers, cost of capital, cost of down time, cost of substitute equipment, facilities or services, or any other special, incidental or consequential damages.

• FAILURE TO COMPLY RISKS EQUIPMENT DAMAGE, FIRE, OR SHOCK HAZARD READ THE ENTIRE OPERATING MANUAL INCLUDING THE LIMIT OF WARRANTY AND LIABILITY BEFORE BUYING OR USING THIS PRODUCT D 01/04 © 1990 Bunn-O-Matic Corporation # CARAFE Page 3 P1300 07. • The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all surfaces on Bunn-O-Matic equipment. Care should be taken not to scratch the windows with any abrasive mate- rial. Regular cleaning will keep your grinder looking new for years. • ADJUSTMENTS (cont.) Burr Adjustment (cont.) Make a mark with a pen on the decal to note the position of the arrow on the grind adjustment screw. The following settings approximately correspond to the CBC recognized grinds. All are referenced from the arrow position noted in step 7.

FINE GRIND: Rotate the adjusting screw 7 hash marks in a counterclockwise direction. • TROUBLESHOOTING A troubleshooting guide is provided to suggest probable causes and remedies for the most likely problems encountered. If the problem remains after exhausting the troubleshooting steps, contact the Bunn-O-Matic Technical Service Department. • Inspection, testing, and repair of electrical equipment should be performed only by qualified service per- sonnel.

• TROUBLESHOOTING (cont.) Problem Grinder will not start. (cont.) Grinder will not shut off.

416 results for g9 led daylight Save this search. Postage to 98837: Items in search results. See more like this G9 LED Bulb 40W Equivalent Daylight Warm White 3000K AC 110-130V 360 Degree Q7U6. From Hong Kong; SPONSORED. Twin Pack G9 LED FILAMENT 2W=20W WARM WHITE/DAY LIGHT CAPSULE LAMPS LIGHT BULBS.

Grinder starts, but will not dis- pense. Incorrect amount of coffee. Incorrect coffee grind dispensed. Probable Cause 4. Off/On/Start switch 2. • SERVICE This section provides procedures for testing and replacing various major components used in this grinder should service become necessary. Refer to Troubleshooting for assistance in determining the cause of any problem.

WARNING - Inspection, testing, and repair of electri- cal equipment should be performed only by qualified service personnel. • SERVICE (cont.) Motor F IN F IN IN JU S AN FI NG T OF E OP Location: The motor is located in the upper wrapper under the hopper. Test Procedure: Remove the hole plug located on the right side of the housing. • SERVICE (cont.) Motor (cont.) 1. Adjusting Screw Locknut 2. Prakticheskie osnovi perevoda kazakova pdf gratis.

Grinder

Adjusting Screw 3. Burr Housing Cap 4. Shear Plate Removal and Replacement - GRIND CHAMBER Refer to the illustration above and remove the two 1/4”-20, hex head screws holding the burr housing cap(3) to the burr housing. • SERVICE (cont.) Off/On/Start Switch CARAFE Location: The Off/On/Start switch is centered in the housing above the upper front inspection panel.